Add as home page    Add to your favourites    Hello,Welcome! 【Login】 【Register】
LED Australia
                                                                         Your Position: Home > Articles > LED/Lighting Knowledge > LED Strip Light

LED Strip Light

Alled / 2013-03-16

LED strip lights with LED assembly in the ribbon of the FPC (flexible printed circuit board) or PCB hard board, its products shaped like a girdle is named. Because long service life (normal life in the 8 to 10 hours), green gradually emerge in a variety of decorative industry. LED lights with conventional into flexible LED lights and LED Rigid Strip two kinds.
With the emergence of LED
lighting design theory along with the advantages of LED in continuous development.
1. Lighting scenarios: based on the needs of the environment to design lighting. Scene lighting to the place as a starting point, which aims to create a beautiful, brilliant light environment, to heighten the scene effect, people feel the scene atmosphere.
2. Mood lighting: is the demand to design lighting. Mood lighting is a human emotion as a starting point to create a mood lighting environments, from a human perspective. Mood lighting includes four aspects: First, environmental protection and energy saving, and is healthy, intelligent, humane.
LED strip lights, LED light bar has been widely used in furniture, automotive, advertising, lighting, ships and other industries.
Installation methods:
(1) four-wire lights bandwidth of about 22mm, a thickness of about 8mm, weighing about 0.25kg / m (4 meters kg)
(2) four-wire lights with a total of four conductors, three rows of lights (Note that not four rows of lights Oh ~ ~), 24 lights each row of 1 meter, 24 * 3 = 72. Every single lamp beads power is 0.05W the 72 beads lamp with power: 72 * 0.05 = 3.6W.
per meter mark "scissors" can only tag was cut, cut the wrong or shear partial cause the meter does not shine! Missed some due marking some, the best is to the shear look carefully before mark The position can at middle not connected snip. Look carefully will be able to see that.
each lamp with must be equipped with a dedicated plug (a plug with a transformer); connection, be sure to remove the clear plastic cover, then good test lamp and then cover. Must not directly lid connection, short circuit so easy!
lamp with installation, usually on the lamp trough placed straight on it, can also be secured with string or thin wire. For the exterior or vertical loading, need another wind Gouka sub and tail plug. The original clamp is fully transparent, it is best to install after marked with a waterproof glass glue, so that in the tail plug and plug waterproof performance is better.
LED strip light can not work EIGHT major reason:
1. LED light bar packaging protection is imperfect, and damage caused during transport lamp beads have been hit.
2. LED light bar solder joints Weld appearance causes does not shine lights with the formation of solder joints falling sensation in the delivery process.
3, LED light bar solder less, solder simple fall.
4. LED light bar solder quality is bad, LED lights with flexible solder simple brittle fracture in the bending process, fall appearance.
5, LED light bar bent viewpoint when the device is too large to form a flexible LED lights with solder and copper foil parting causes does not shine.
6. LED light bar device over-kneading product, resulting in LED lights with flexible chip damaged or solder joint deformation fall but not bright.
7. LED light bar PCB solder mask layer is too thick, solder and soldering circuit boards can not be thoroughly blend, also a Weld appearance.
8. LED light bar can not distort the device, if distorted the formation of solder joints LED lights with flexible drop causes does not shine.

LINK:
Home Company Profile Shipping & Freight info Payment Support Sitemaps

© 2005-2019 ALLED Copyright, All Rights Reserved.
Tel: 0285990000 E-mail: info@alled.com.au